Picture Your BEST ROOFING COMPANIES On Top. Read This And Make It So

When was the final time the roof of your building was inspected? If it’s been awhile, the roof may have problems lurking that require immediate attention. Some roof problems cause obvious signs such as leaks, while some produce subtle signs that are only detectable on the surface. In either case, leaving the problems unaddressed can cost you thousands once you finally repair them. If the roof on your own building has the problems listed below, a company that focuses on commercial roofing should repair them quickly:

Buckled Panels

Roof panels buckle due to weather damage and poor installation. Whatever the cause, the buckling allows wind to blow underneath the panels, making them loose. Because the problem worsens, the panels start to fall off, often coming off in large sections when a storm hits. Buckled panels are perhaps one of the most commonly fixed problems by companies that perform roof repair.

Expended Screw Holes

Expanded screw holes are another problem for panel roofs. Over time, wind and fluctuating temperatures cause the screw holes in panels to widen round the screws that contain the panels in place. This creates a space where water can leak underneath the panels and soak the roof deck. Once the deck becomes saturated, the thing is costly to fix.

Blistering

Improper heating procedures and dry lapping cause hot bituminous roof systems to blister. Although small blisters seldom pose a problem, large ones can rupture and invite water to seep under the bitumen. After the blisters form, warm weather typically makes them worse. As a result of humid subtropical climate in some regions of the country, commercial roofing frequently experiences blistering.

Ponding Water

Blocked drains and improper sloping can cause water to assemble in small ponds on a roof. Repairing a blocked drain is simple, but fixing a sloping problem is more complex. Often, installing a taper insulation system to establish a new slope is the better solution. During the rainy season, resolving ponding water is among the most common types of roof repair.

Loose Flashing

Flashing prevents water from seeping in the crevice where in fact the roof abuts to protrusions such as chimneys and vents. As time passes, most flashing must be resealed. If it’s not, leaks may cause serious damage the deck and building interior. Roof moss removal near me flashing problems are corrected during the course of scheduled maintenance.

Missing Mortar

Chimneys and high parts of brick walls that have sections of missing mortar may cause leaks. These leaks are often mistaken for leaks in the roof membrane, but a thorough inspection by a company that specializes in commercial roofing will reveal the true problem. Most sections of missing mortar could be repaired with basic tuck pointing procedures.

Conclusion

The problems above are a few of the most common known reasons for roof repair. When they are corrected early, most problems are inexpensive to fix, however, not addressing them until they cause serious problems may necessitate roof replacement. Having a scheduled maintenance agreement with a roofing company is the best way to ensure problems are detected early.

Leave a Reply

Your email address will not be published. Required fields are marked *